A. Before operating, please read following points carefully:
■ Check if the package is intact and presetter is in good condition;
■ Unfasten the set screws, and fasten it with adjusting screws included in package;
■ Clean with anti-rust oil. No gasoline, nor any solvent with acetone.
B. Checking the following points before operating：
■ Unfasten the set screw on X axis (See yellow pasters on this equipment);
■ Unfasten the set screw on Z axis (See yellow pasters on this equipment);
■ Check the lubrication system;
■ Clean the spindle;
■ Clean the test bar;
■ Before every operation, Procedures 4 and 5 aforementioned shall be done.
C. Notices：
■ Move the Z-axis with one hand;
■ No pulling nor pushing Z-axis brutally; Please push the Z-axis gently approaching the tool and then micro adjust with one hand;
■ Please don’t touch probe with the cutting edge to avoid any damage to probe and meter.